1. Locking Arm Standoffs
Start by assembling the locking arm standoffs, using 2 x M3x6 flat head screws, and 2 x 5mm threaded standoffs
2. Install standoffs
Install standoffs as shown and tighten M3x6 FH screw.
3. Locking Arms And Top Plate
The locking arms attach to the top plate using 2 x M3x10 FH screws, 2 x 1mm spacer, and 2 M3 locknuts.
3. Attach Locking Arms to Top Plate
Place the 1mm spacer between the arm and the top plate. Lightly tighten the locknut until it is snug, then slightly backoff until the arm rotates freely.
4. Arm Orientation (open)
The arms should be oriented as shown. The magnets should not be visible from the top.
5. Arm Orientation (closed)
The arms should be oriented as shown. The magnets should not be visible from the top.
6. Battery End Plates
The battery end plates should be installed onto the Wasp chassis first. The parts needed are the 2 endplates, 4 x M3x16 FH screws, 4 x 4mm spacers, 4 x 1mm spacers (*note some hardware kits may have 8 x 2mm spacers, use 2 x 2mm spacers instead of 1 x 4mm spacer)
7. End plate Installation
Insert the 4 x M3x16 FH screws into the bottom of the chassis. Add a 4mm and 1mm spacer to each screw, then add the end plate to the screws on each side, as shown. (*note some hardware kits may have 8 x 2mm spacers, use 2 x 2mm spacers instead of 1 x 4mm spacer)
8. Install 20 mm Standoffs
Install a 20mm standoff on each screw until slightly loose. Do not fully tighten down standoffs yet.
9. Top Plate
Install the top plate onto the standoffs using 4 x M3x8 FH screws.
10. Install Top Plate
Fully tighten down the 4 x M3x8 FH screws.
11. Upper Stay Mount Bar
The upper stay mount bar is installed used 2 x M3x6 FH screws
12. Use slots in chassis
Use the slots in the chassis to hold the M3x6 FH screw in place.
13. Use slots in chassis
Fully tighten the M3x6 FH screws.
14. Mount Bar Raised Area
Make sure the raised area of the mount bar visible.
15. Upper Stay
Install the upper stay using the included M3x6 button head screws.
16. Upper Stay Install
Mounted Upper stay (do not use the M3x8 BH screws that came with the upper stay originally as they will be too long).
17. Adjust Battery End Plates
Adjust the battery end plates to fit your shorty thin battery. Leave a little extra room to allow the battery to lift out easily. Tighten down M3x16 FH screws on the bottom of the chassis.
18. Optional Configuration
If you want to use shorty thick batteries (<25mm) , you can modify the locking arms and change the placement of the spacers below the battery end plates.
19. Optional Configuration
Remove the 1 mm spacer and the 5mm standoff from the locking arms.
20. Optional Configuration
Put the 1mm spacer below the end plate, and move the 4mm spacer above it.
21. Optional Configuration
Or you can put both spacers above the end plate